﻿1、功能说明
    1、TIM2周期门控TIM3，TIM3周期门控TIM4    
2、使用环境
    软件开发环境：KEIL MDK-ARM V5.34.0.0
                 IAR EWARM 8.50.1
    硬件开发环境： 
        N32A052系列：
            基于评估板N32A052KBQX_STB V1.0开发

3、使用说明
    系统配置:
        1、时钟源：
                    HSI=8M,SYS CLK=64M,TIM2 CLK=64M,TIM3 CLK=64M,TIM4 CLK=64M
        2、端口配置：
                    PA10选择为TIM2 CH1输出
                    PC6选择为TIM3 CH1输出
                    PD11选择为TIM4 CH1输出
        3、TIM：
                    TIM2 的周期门控TIM3，TIM3的周期门控TIM4
    使用方法：
        1、编译后打开调试模式，用示波器或者逻辑分析仪观察TIM2 CH1，TIM3 CH1，TIM4 CH1波形
        2、TIM3 4倍周期TIM2，TIM4 4倍周期TIM3
4、注意事项
       开发板默认PA9,PA10跳帽接到NSLINK的虚拟串口，若工程中PA9，PA10不作串口，用作其他用途，须拔掉串口跳帽。
	
	
	
1. Function description
     1. TIM2 cycle gate TIM3, TIM3 cycle gate TIM4
2. Use environment
	Software development environment: KEIL MDK-ARM V5.34.0.0
                                      IAR EWARM 8.50.1
    Hardware development environment:
         N32A052 series:
            Developed based on the evaluation board N32A052KBQX_STB V1.0
3. Instructions for use
    System Configuration;
        1. Clock source:
                    HSI=8M,SYS CLK=64M,TIM2 CLK=64M,TIM3 CLK=64M,TIM4 CLK=64M
         2. Port configuration:
                     PA10 is selected as TIM2 CH1 output
                     PC6 is selected as TIM3 CH1 output
                     PD11 is selected as TIM4 CH1 output
         3. TIM:
                     TIM2 cycle gating TIM3, TIM3 cycle gating TIM4
     Instructions:
         1. After compiling, turn on the debug mode, and use an oscilloscope or logic analyzer to observe the waveforms of TIM2 CH1, TIM3 CH1, and TIM4 CH1
         2. TIM3 4 times cycle TIM2, TIM4 4 times cycle TIM3
4. Matters needing attention
        By default, the PA9 and PA10 jumper caps of the development board are connected to the virtual serial port of NSLINK. If PA9 and PA10 are not used as serial ports in the project, and are used for other purposes, the serial port jumper caps must be unplugged.
