1、功能说明

	1、此例程展示在 RT_Thread 系统创建 DAC 设备

2、使用环境

	/* 硬件环境：工程对应的开发硬件平台 */
	开发板：N32L43XM-STB N32L40XM-STB V1.1

3、使用说明
	
	/* 描述相关模块配置方法；例如:时钟，I/O等 */
	SystemClock：108MHz
	GPIO:  LED:	D1--PA8
        ADC:
				PC0选择为模拟功能ADC转换通道
        DAC:
				PA4选择为模拟功能DAC OUT
    	串口：  	
				TX--PA9


	/* 描述Demo的测试步骤和现象 */
	1.编译后下载程序复位运行
    2.本例程在main()里面创建两个线程，test0 线程和 test1 线程，test0 线程用于控制 D1 250ms闪烁，
      在test1线程测试 DAC 设备，用跳线连接 PA4 和 PC0，用 ADC 测量 DAC 的输出，通过串口打印。

4、注意事项
	无

1. Function description
    This routine shows how to create an DAC device on the RT_Thread system

2. Use environment
    Hardware environment: development hardware platform corresponding to the project 
    Development board:      N32L43XM-STB N32L40XM-STB V1.1

3. Instructions for use
    Describe the configuration method of related modules; for example: clock, I/O, etc. 
        1. SystemClock：108MHz
	2. GPIO:  LED:	D1--PA8
        3. ADC:
        	PC0 is selected as the analog function ADC1 conversion channel
        4.DAC:
                PA4 is selected as the analog function DAC1 OUT
        Log(USART1): TX--PA9 Baud rate: 115200

    Describe the test steps and phenomena of Demo 
        1. After compiling, download the program to reset and run;
        2. This routine creates two threads in main(), test0 thread and test1 thread, test0 thread is used to control D1 250ms flashing, test1 thread is used to test the DAC device, 
            connect PA4 and PC0 with jumper, measure DAC output with ADC, print through serial port

4. Attention
    None.