1、功能说明

    此例程提供了一种DMA用法，用于在外设到RAM之间传输数据。
    
2、使用环境

	软件开发环境：
        IDE工具：KEIL MDK-ARM 5.26
    
    硬件环境：
        开发板 N32G43XRL-STB V1.0


3、使用说明
	
    1、时钟源：HSE+PLL
    2、主时钟：108MHz
    3、DMA通道：DMA_CH2，DMA_CH3，DMA_CH4，DMA_CH5
    4、SPI1 配置：
            SCK   -->  PA5
            MISO  -->  PA6
            MOSI  -->  PA7
            全双工
            主模式
            8bit传输
            极性：起始为低/第二个边沿
            软件片选
            大端在前MSB
    
    5、SPI2 配置：
            SCK   -->  PB13
            MISO  -->  PB14
            MOSI  -->  PB15
            全双工
            从模式
            8bit传输
            极性：起始为低/第二个边沿
            软件片选
            大端在前MSB
    
    6、USART1配置：
            TX  -->  PA9
            波特率：115200
            数据位：8bit
            停止位：1bit
            无校验

    7、测试步骤与现象
        a，编译下载代码复位运行
        b，从串口看打印信息，验证结果
        
4、注意事项
    无


1. Function description
    This routine provides a DMA usage for transferring data between peripherals and RAM.
    
2. Use environment
    Software Development environment:
	IDE tool: KEIL MDK-ARM 5.26   
    Hardware environment:
	Development board N32G43XRL-STB V1.0

3. Instructions for use
    1. Clock source: HSE+PLL
    2. Master clock: 108MHz
    3. DMA channels: DMA_CH2, DMA_CH3, DMA_CH4, DMA_CH5
    4. SPI1 configuration:
        SCK   -->  PA5
        MISO  -->  PA6
        MOSI  -->  PA7
	Full duplex
	Main mode
	8 bit transmission
	Polarity: start at low/second edge
	Piece of software to choose
	Big end in front MSB    
    5. SPI2 Configuration:
        SCK   -->  PB13
        MISO  -->  PB14
        MOSI  -->  PB15
	Full duplex
	From the pattern
	8 bit transmission
	Polarity: start at low/second edge
	Piece of software to choose
	Big end in front MSB    
    6. USART1 configuration:
	TX --> PA9
	Baud rate: 115200
	Data bit: 8 bits
	Stop bit: 1bit
	No check
    7. Test steps and phenomena
	a. Compile download code reset run
	b. View the printed information from the serial port and verify the result
        
4. Attention
    None