1˵
	1STANDBYģʽĽ˳


2ʹû

    KEIL MDK-ARM V5.25

    Ӳ
		1N32L40XRL-STB V1.0
		2MCUN32L406RBL7


3ʹ˵
	
	ϵͳã
		1ʱԴHSE+PLL
		2ʱƵʣ64MHz
        3ԴPA0
               
    ʹ÷
        KEIL±¼壬ϵϵֵmAuAMCUӡMCU Goto Standby!
        »Ѱ(PA0),ֻصmA𣬹һֽuA,ӡMCU Reset


4ע
	ĵʱҪעȥLEDȥ



1. Function description
    1. Enter and exit STANDBY mode.

2. Use environment
    Software development environment: KEIL MDK-ARM V5.25
    Hardware environment:
	1, Based on the evaluation board N32L40XRL-STB V1.0 development
	2, MCU: N32L406RBL7

3. Instructions for use   
    System configuration;
	1. Clock source: HSE+PLL
	2. Clock frequency: 64MHz
	3. Wake up source: PA0
               
    Instructions:
	After compiling under KEIL, it was burned to the evaluation board, connected to the ammeter, and found that the current dropped from mA to uA level after powering on, and THE MCU printed "MCU Goto Standby!"
	Press the wake up button (PA0), and the current returns to mA level. After a while, it drops to uA and prints "MCU Reset".

4. Matters needing attention
    When evaluating power consumption, take care to remove the LED to measure
