1˵
    1TIM13·
2ʹû
      KEIL MDK-ARM V5.34.0.0
    Ӳ        N32G003F5S7-STB V1.0
3ʹ˵
    ϵͳ:
        1ʱԴ
                    AHB=48M,APB=48M,TIM1 CLK=48M
        2˿ã
                    PA11 ѡΪTIM1 CH1
                    PA7 ѡΪTIM1 CH2
                    PA10 ѡΪTIM1 CH3
                    PA5 ѡΪTIM1 CH1N
                    PA6 ѡΪTIM1 CH2N
                    PA2 ѡΪTIM1 CH3N
                    PA1 ѡΪTIM1 Breakin
        3TIM
                    TIM1 6·IOMɲ
    ʹ÷
        1򿪵ģʽʾ߼ǹ۲TIM1Ĳ
        2ɹ۲쵽3·ΣPA1Ϊ߿ɹر
4ע
       ĬPA2,PA3ñӵNSLINK⴮ڣPA2PA3ڣ;εñ

1. Function description
    1. TIM1 output 3 complementary waveforms
2. Use environment
    Software development environment: 	KEIL MDK-ARM V5.34.0.0
    Hardware environment:    	             	N32G003F5S7-STB V1.0
3. Instructions for use
    System configuration:
        1. Clock source:
            AHB=48M, APB=48M, TIM1 CLK=48M
        2. Port configuration:
                     PA11 is selected as TIM1 CH1 output
                     PA7 is selected as TIM1 CH2 output
                     PA10 is selected as TIM1 CH3 output
                     PA5 is selected as TIM1 CH1N output
                     PA6 is selected as TIM1 CH2N output
                     PA2 is selected as TIM1 CH3N output
                     PA1 is selected as TIM1 Breakin input
        3. TIM:
            TIM1 3 Complementary with dead-time, with IOM Brake
    Instructions:
        1. Open debugging mode after compilation and observe TIM1 waveform with oscilloscope or logic analyzer
        2. 3 complementary waveforms can be observed, and the output of PA1 pin can be turned off when the pin is high
4. Matters needing attention
    By default, the PA2 and PA3 jumper caps of the development board are connected to the virtual serial port of NSLINK. If PA2 and PA3 are not used as serial ports in the project, and are used for other purposes, the serial port jumper caps must be unplugged.
