1˵

    òʾUSARTyUSARTzͨжʵֵĻͨš
    USARTyTxBuffer1USARTzUSARTzݴRxBuffer2ͬʱ
USARTzTxBuffer2USARTyUSARTyݴRxBuffer1
    󣬷ֱȽ뷢ݣȽϽTransferStatus1
TransferStatus2
    USARTyUSARTzUSART1USART2


2ʹû

    KEIL MDK-ARM Professional Version 5.26.2.0

    ӲСϵͳN32G031C8L7-STB V1.0


3ʹ˵
	
    ϵͳʱ£
    - ʱԴ = HSI + PLL
    - ϵͳʱ = 48MHz
    
    USART£
    -  = 115200 baud
    - ֳ = 8λ
    - 1ֹͣλ
    - Уƽ
    - ӲƽãRTSCTSźţ
    - ͷʹ
    
    USART£    
    - USART1_Tx.PA9    <------->    USART2_Rx.PA3
    - USART1_Rx.PA10   <------->   USART2_Tx.PA2

    
    Բ
    - DemoKEIL±MCU
    - λУβ鿴TransferStatus1TransferStatus2У
      PASSEDΪͨFAILEDΪ쳣


4ע

    ȽNS-LINKMCU_TXMCU_RXñϿ

1. Function description

    This test case demonstrates the basic communication between USARTy and USARTz through interrupts.
    USARTy sends TxBuffer1 data to USARTz, and USARTz receives data to RxBuffer2. At the same time, USARTz sends TxBuffer2 
data to USARTy, and USARTy receives data to RxBuffer1.
    Subsequently, the two groups of received data and sent data are compared respectively, and the comparison results are 
stored in the TransferStatus1 variable and the TransferStatus2 variable.
    USARTy and USARTz can be USART1 and USART2.


2. Use environment

    Software development environment: KEIL MDK-ARM Professional Version 5.26.2.0

    Hardware environment: minimum system board N32G031C8L7-STB V1.0


3. Instructions for use

    The system clock configuration is as follows:
    -Clock source = HSI + PLL
    -System clock = 48MHz
    
    The USART configuration is as follows:
    -Baud rate = 115200 baud
    -Word length = 8 data bits
    -1 stop bit
    -Verification control disabled
    -Hardware flow control disabled (RTS and CTS signals)
    -Receiver and transmitter enable
    
    The USART pin connections are as follows:
    -USART1_Tx.PA9 <-------> USART2_Rx.PA3
    -USART1_Rx.PA10 <-------> USART2_Tx.PA2

    
    Test steps and phenomena:
    -After the Demo is compiled in the KEIL environment, download it to the MCU
    -Reset operation, check the variables TransferStatus1 and TransferStatus2 in turn, among them,
      PASSED means the test passed, FAILED means the test is abnormal


4. Matters needing attention

    the MCU_TX and MCU_RX jumper cap of the development board NS-LINK needs to be disconnected first